Are your photos sharp or soft?

0
884

Two common words in photography are ‘sharp’ and ‘soft’, and photographically speaking there is an enormous difference between them.  Those terms are the ones reserved for describing whether the final image is well focused.  We speak about ‘sharp’ focus and ‘soft’ focus and everyone knows what is meant.

While ‘soft’ focus is not all that difficult to end up with, and you can buy after-market filters to do this, ‘sharp’ focus is a lot more difficult to attain, so I thought it might be worthwhile looking at what you have to do to get pin-sharp photographs.

Forgetting all about Auto-Focus (AF) problems and camera shake for the moment, the deciding factor on whether or not you get sharp pictures will depend upon the quality of the optics in the lenses you use.  Unfortunately quality costs money – like most consumer items.  “You get what you pay for” works in photography just the same as it does anywhere else!

I came across this fundamental truth when I was becoming despondent with the sharpness of my final prints many years ago.  Even putting the camera on a tripod had not helped.  Asking around in my photographer acquaintances led to my being loaned a very battered and well used journalist’s Nikon FM2N, with Nikon lens.

I took the “old” camera away and shot a roll of film.  Off to the darkroom and guess what?  Every one as sharp as a tack.  I had learned an important lesson and went out and purchased some second hand Nikon equipment, and have never regretted it since.  In fact, old FM2N Nikons were still part of my camera equipment till very recently.

So what was the difference?  Well, the end result will always rely on super sharp optics in the lens department.  If they are not spot on, neither will your photos be spot on.  The actual exposures are close enough for just about any camera these days with the latitude in the electronics being so wide, so the other differences now will come down to ease of use, or user friendliness.  Simple mechanical cameras, like the FM2, have simple operations too.  These new electronic cameras with their “menus” and other operations I do not consider to be as user friendly.  It is easier to push a lever, surely.  However, perhaps it might just be that I am resistant to change!

The important lesson from all that is that to get good results you need a camera that has good optics.  There are plenty on the market these days, and although the Nikon brand may be my favorite, there are other manufacturers which have equally as good quality glass at the front.  Unfortunately, the results from these great cameras can become poor if you put a cheap “after market” lens on it.  Good lenses are expensive, but the end result is always worth it.

Having mentioned AF problems earlier, a few words on this again.  While AF is now almost 100 percent universal, it still is not 100 percent foolproof.  One of the reasons for this is quite simple.  The camera’s magic eye doesn’t know exactly what subject(s) you want to be in focus and picked the wrong one!  The focusing area for the AF system is a small circle or square in the middle of the viewfinder, so if you are taking a picture of two people two meters away, the camera may just focus on the trees in the far distance that it can see between your two subjects.  Those trees are two km away, so you get back a print with the background sharp and the two people in the foreground as soft fuzzy blobs.  The fix is to focus on one person, use the ‘focus lock’ and recompose the picture.

Finally – camera shake.  Cameras are supposed to be operated with two hands, not one.  The practice of holding the camera in one hand and raising one, two and three fingers on the other can only lead to camera shake.  Don’t do it.  If you must tell your subjects that you are about to trip the shutter, do it by saying the words “one, two, three” – not by waving your fingers in the air.